Description
Good Quality Closed End Replacement Wheel Nuts
Please check compatibility
Technical Specification
Zinc Plated cover, 12×1.5mm Thread, 26mm Deep with closed end, Taper Seat with captive washer & Uses a 19mm Socket/Wrench
Important Information
Always compare the seating and thread with the original equipment fitted, The Manufacturer Strongly recommends that each installation should be inspected during fitment and thoroughly checked after fitment (by spinning the wheel if necessary) after 200 miles or 300km use. Torque settings should be in accordance with vehicle manufacturers recommendations. If you are unsure about any aspect of fitting do not attempt to fit but contact your local dealer. Your wheel hubs or brakes may be adversely affected by wrongly fitted wheel nuts. Do not use air guns to fit.
Reviews
There are no reviews yet.